.jpg "Opportunities, Appliacation, Openings"){kind=small}
.jpg "Hand Job, Blow Job, Job Search, Monster Job"){kind=small}
.jpg "pusat resume, daftar kerja, cari kerja"){kind=small}
.jpg "Project Manager, SOftware Engineer, SAP Consultant"){kind=small}
Weird problem with OSPF
Aamir,
do you have some virtual-link configuration under ospf?
Once (when I try to lab it IEWB lab 1 at my poor home lab) I noticed that if I enter virtual link config first, and then neighbor statement, I got the same output (OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint networks).
But when I entered these commands in reverse order (first neighbor, than virtual link), then everything was ok.
HTH, Srdja
—–Original Message—– From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Aamir Aziz Sent: Friday, September 01, 2006 14:57 To: ccielab@groupstudy.com Subject: Weird problem with OSPF
HI there ppl,
I have a hub and spoke environment like this R2——-R5——-R3,
R5 is the hub with s0/0.235 multipoint interface meaning by default NBMA mode, which requires neighbor command on R5 but when i reboot R5 i get this error :
OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint networks OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint networks
and the neighbor command is no longer there in OSPF of R5, what is happening here?? i have given ip ospf priority 0 on R2 and R3 to R5 as DR
Thanks Aamir
