.jpg "Opportunities, Appliacation, Openings"){kind=small}
.jpg "Hand Job, Blow Job, Job Search, Monster Job"){kind=small}
.jpg "pusat resume, daftar kerja, cari kerja"){kind=small}
.jpg "Project Manager, SOftware Engineer, SAP Consultant"){kind=small}
SPAN direction
Or you can use “both” option to monitor the traffic both ways
HTH
2008/5/14 Matt Bentley :
> Hello: > > It would be TX - the rx/tx refers to what direction traffic is traversing > the interface. If it is traffic coming INTO the interface, it would be > RX. > If traffic LEAVING the interface, it would be TX. > > HTH > > On Tue, May 13, 2008 at 8:43 PM, Athaide, Dwayne > wrote: > > > If I was to monitor all traffic coming “from” port f0/1 on Sw1. Would > > that > > be rx in my monitor session or “tx” > > > > Monitor session 1 source int f0/1 “rx/tx” > > > > Thanks > > > > > > _______________________________________________________________________ > > Subscription information may be found at: > > http://www.groupstudy.com/list/CCIELab.html > > > _______________________________________________________________________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html > > > > >
— Muhammad Nasim Network Engineer Saudi Arabia
