Go CCIE Go!! - A Cisco Certified Internetwork Expert

first two can be done Cannot configure VLANs from config mode (only vlan database) * Cannot change VTP Mode on newer ios these are supported .... ...

Port Security can be configured on Access port as well as Trunk port, only with the exception that it does not support dynamic behavior where DTP comes into the picture. ...

Hi all I am getting CRC error from the I/F connected to my SAN Box. Primary is connected to 6513 and Secondary on 4509 [DR site] , Sync is setup across the SAN Devices. SAN architect asked me to configure 100meg Full on both the site . SAN fabric is connected to the patch with a cat6 cable and from there to the 6513 a cat5e , will there be any issue due to this factor ? interface GigabitEthernet10/25 description Centera Server Primary switchport switchport access vlan 10 switchport mode access switchport nonegotiate no ip address speed 100 duplex full I have notices more runts and Giant packets on the i/f traffic Regards Vineesh _________________________________________________________________ http://clk.atdmt.com/UKM/go/msnnkmgl0010000009ukm/direct/01/ ...