Go CCIE Go!! - A Cisco Certified Internetwork Expert

What about enabling ospf with the interface statement? Eg interface-config> ip ospf 1 area x
HTH
Phill D
—–Original Message—– From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Chan Hong Sent: 10 March 2008 12:12 To: YourPal; Cisco certification Subject: Re： Enabling OSPF using minimum network statements
If there is another task request you to enable another ospf area on int fa0/0 and s0/0. Then can I use “network 0.0.0.0 0.0.0.0 area 0″ to meet this task requirement??
—– 6l%s-l%s —- 1H%s$H!R YourPal &,%s$H Cisco certification 6G0e$i4A!R 2008 &~ 3$k 9 $i ,P4A$i $U$H 8:24:11 %DCD!G Enabling OSPF using minimum network statements
Hi Group,
A router has the following IP addresses:
! interface FastEthernet0/0 ip address 154.1.38.3 255.255.255.0 ! interface FastEthernet0/1 ip address 154.1.3.3 255.255.255.0 ! interface Serial0/0 ip address 154.1.0.3 255.255.255.0 ! interface Serial0/2 ip address 154.1.13.3 255.255.255.0 ! interface Serial0/3 ip address 154.1.23.3 255.255.255.0 !
The task requires to enable OSPF area 0 on interfaces Fa0/1, s0/2, and s0/3 using the minimum amount of network statements necessary. Do not enable area 0 on any other interfaces.
As hard as I tried, I’m not able to use minimum network statements to cover those 3 interfaces without covering s0/0. So I configured 3 statements as follows (to me, this is the min.):
! router ospf 1 network 154.1.3.3 0.0.0.0 area 0 network 154.1.13.3 0.0.0.0 area 0 network 154.1.23.3 0.0.0.0 area 0 !
Let me know if you have a solution that meets the task requirement.
Thank you.
BR, Emil