Go CCIE Go!! - A Cisco Certified Internetwork Expert

I dont get any such warning ..
SW1(config)#do sh etherchannel load EtherChannel Load-Balancing Configuration: dst-mac
EtherChannel Load-Balancing Addresses Used Per-Protocol: Non-IP: Destination MAC address IPv4: Destination MAC address IPv6: Destination MAC address
SW1(config)# SW1(config)#port-c load dst-ip SW1(config)#do sh etherchannel load EtherChannel Load-Balancing Configuration: dst-ip
EtherChannel Load-Balancing Addresses Used Per-Protocol: Non-IP: Destination MAC address IPv4: Destination IP address IPv6: Destination IP address
May be some issue in IOS version you are using .
Gaurav Madan
On Wed, Sep 24, 2008 at 11:17 PM, KS Anpu wrote: > When i am configuring the load balancing method in a port channel , i am > getiing this Warning: message but configuration is changed …. is it > default behavior ? > > *SW2(config)#port-channel load-balance dst-mac > Warning: Delete and re-create existing port channels to apply new load > balance method to them > > SW2(config)#do sho ether load > Po2 —> Source XOR Destination IP address* > > > Regards, > Anbu > > > Blogs and organic groups at http://www.ccie.net > > _______________________________________________________________________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net