Go CCIE Go!! - A Cisco Certified Internetwork Expert

It is in Dynamips. and IOS is c3640-jk9o3s-mz.123-14.T7.bin
Regards, Anbu
On Wed, Sep 24, 2008 at 11:26 PM, GAURAV MADAN wrote:
> I dont get any such warning .. > > SW1(config)#do sh etherchannel load > EtherChannel Load-Balancing Configuration: > dst-mac > > EtherChannel Load-Balancing Addresses Used Per-Protocol: > Non-IP: Destination MAC address > IPv4: Destination MAC address > IPv6: Destination MAC address > > SW1(config)# > SW1(config)#port-c load dst-ip > SW1(config)#do sh etherchannel load > EtherChannel Load-Balancing Configuration: > dst-ip > > EtherChannel Load-Balancing Addresses Used Per-Protocol: > Non-IP: Destination MAC address > IPv4: Destination IP address > IPv6: Destination IP address > > > May be some issue in IOS version you are using . > > Gaurav Madan > > On Wed, Sep 24, 2008 at 11:17 PM, KS Anpu wrote: > > When i am configuring the load balancing method in a port channel , i am > > getiing this Warning: message but configuration is changed …. is it > > default behavior ? > > > > *SW2(config)#port-channel load-balance dst-mac > > Warning: Delete and re-create existing port channels to apply new load > > balance method to them > > > > SW2(config)#do sho ether load > > Po2 —> Source XOR Destination IP address* > > > > > > Regards, > > Anbu > > > > > > Blogs and organic groups at http://www.ccie.net > > > > _______________________________________________________________________ > > Subscription information may be found at: > > http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net