.jpg "Opportunities, Appliacation, Openings"){kind=small}
.jpg "Hand Job, Blow Job, Job Search, Monster Job"){kind=small}
.jpg "pusat resume, daftar kerja, cari kerja"){kind=small}
.jpg "Project Manager, SOftware Engineer, SAP Consultant"){kind=small}
Per-Port Per-VLAN marking
The per-port per-VLAN QoS feature enables you to specify different QoS configurations on different VLANs on a given interface. You will need to embed your class-map that mathches all in your class map that matches the vlan, such as
access-list 1 permit any
class-map match-all ANY match access-group 1 ! class-map match-all VLAN match vlan 5 match class-map ANY ! policy-map VLAN_IP class VLAN set precedence 4
—–Original Message—– From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Udo Konstantin Sent: Saturday, August 19, 2006 9:48 PM To: CCIE Groupstudy Subject: Per-Port Per-VLAN marking
Hi all,
I had the following challange…
On a switch (3550) mark all incoming traffic from VLAN x with precedence 4 As I understand I should use per-port per-vlan marking Right now I configure
class-map match-all PREC4 match vlan X policy-map PREC class PREC4 set ip precedence 4
when I apply this policy-map to a interface on a switch assume fa0/6 the map would be rejected because I need another one more statement under class-map config. This is what I understand. So I configure an access-list 101 and with match access-group I apply it as an additional statement into the class map But right now I’m not sure if this really works… Maybe anyone here had anything like this configured an can send an example ??!
thanks Udo
___________________________________________________________ Telefonate ohne weitere Kosten vom PC zum PC: http://messenger.yahoo.de
