.jpg "Opportunities, Appliacation, Openings"){kind=small}
.jpg "Hand Job, Blow Job, Job Search, Monster Job"){kind=small}
.jpg "pusat resume, daftar kerja, cari kerja"){kind=small}
MPLS command on the interface (mpls ip) (tag ip) ?
Same thing. Some versions of code accept “mpls ip” but put “tag-switching ip”. Some versions of code accept “tag-switching ip” but put “mpls ip”. It is just present to support upgrades and legacy configuration scripting.
David
– http://dcp.dcptech.com
> —–Original Message—– > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On > Behalf Of marc fernandez > Sent: Tuesday, May 13, 2008 5:35 PM > To: ccielab@groupstudy.com > Subject: MPLS command on the interface (mpls ip) (tag ip) ? > > Question: if I am configuring mpls label ranges, protocol > either ldp tdp. > What is the difference on the interface command if it > supports (mpls ip ) > or (tag ip)? Is there a major difference? If so can you share some > experience or links on the subject? I’ve run into situations where the > router only supports one of the commands and not both. > > example: > > mpls label protocol ldp > mpls label range 20 40 > mpls ldp router-id loopback0 > > int f0/0.99 > mpls ip > > or > > int f0/0.99 > tag ip > > > ______________________________________________________________ > _________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html
