Go CCIE Go!! - A Cisco Certified Internetwork Expert

no, there were at least 4 ports on vlan 567.
On Mon, Jan 12, 2009 at 12:14 AM, Darby Weaver wrote: > Is f0/7 the only port in vlan 567? > > > > On Sun, Jan 11, 2009 at 7:28 PM, Jason Morris wrote: >> >> ok, i’m having some issues with the ‘ingress’ portion of the monitor >> it would appear. I’ve done this 100 times in real life and now i >> can’t seem to get it to work in a lab. am i missing something or does >> ingress work differently on the 3560 or what? thoughts? >> >> 150.100.220.7 is connected to f0/7 of this switch. >> >> see the output below >> >> Cat-2(config)#do sho run | i monitor >> monitor session 1 source interface Fa0/15 >> monitor session 1 destination interface Fa0/7 ingress untagged vlan 567 >> Cat-2(config)#do sho run int f0/7 >> Building configuration… >> >> Current configuration : 85 bytes >> ! >> interface FastEthernet0/7 >> switchport access vlan 567 >> switchport mode access >> end >> >> Cat-2(config)#do sho run int vlan 567 >> Building configuration… >> >> Current configuration : 68 bytes >> ! >> interface Vlan567 >> ip address 150.100.220.12 255.255.255.240 >> end >> >> Cat-2(config)#do ping 150.100.220.7 repeat 15 >> >> Type escape sequence to abort. >> Sending 15, 100-byte ICMP Echos to 150.100.220.7, timeout is 2 seconds: >> …………… >> Success rate is 0 percent (0/15) >> >> Cat-2(config)#no monitor session 1 destination int f0/7 >> Cat-2(config)#do ping 150.100.220.7 repeat 15 >> >> Type escape sequence to abort. >> Sending 15, 100-byte ICMP Echos to 150.100.220.7, timeout is 2 seconds: >> ……….!!!!! >> Success rate is 33 percent (5/15), round-trip min/avg/max = 1/2/8 ms >> Cat-2(config)# >> >> >> Blogs and organic groups at http://www.ccie.net >> >> _______________________________________________________________________ >> Subscription information may be found at: >> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net