Go CCIE Go!! - A Cisco Certified Internetwork Expert

Hi Igor,
One trick i follow is drawing the switches with the physical connections and trunks. Then run over the Diagram and writing vlans numbers. Then check for transit Vlans. Lets say SW1 —-> SW2 ——> SW3 then if we have vlan100 in sw1 and sw3 and the only route between those 2 switches is through sw2 then you should add vlan100 to sw2.
HTH
On Tue, Sep 16, 2008 at 10:38 AM, Igor M. wrote:
> I normally go through L2/L3 diagrams in the IE and I do the minimum that I > see required at the moment. Along the way I do the lab, and if I realize > that one is missing - just go ahead and add it. That way, incrementally, but > you still keep it to a minimum… > > ———————- > > I.M., M.Eng. P.Eng. > > Network Architect > > CI Investments > > ———————- > > — On Tue, 9/16/08, Atlanta CCIE wrote: > From: Atlanta CCIE > Subject: Minimum VLAN Configuration > To: “Cisco certification” > Received: Tuesday, September 16, 2008, 1:30 PM > > I am not sure about others but I have hard time trying to figure out the > minimum numbers of VLANs needed by looking at the diagram. What method do > you guys use to come up with this? I tried looking at the topology diagrams > but I always leave some vlans out that are not on the diagram but in the > IE’s SG. Any help would be highly appreciated > > > Blogs and organic groups at http://www.ccie.net > > _______________________________________________________________________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html > > > Blogs and organic groups at http://www.ccie.net > > _______________________________________________________________________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net