Go CCIE Go!! - A Cisco Certified Internetwork Expert

Udo, There is a link at Cisco UniverCD, http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fsec ur_c/ftrafwl/scflock.htm#wp1001165
HTH Victor.-
—–Mensaje original—– De: nobody@groupstudy.com [mailto:nobody@groupstudy.com] En nombre de Udo Konstantin Enviado el: Domingo, 20 de Agosto de 2006 03:58 p.m. Para: CCIE Groupstudy Asunto: Lock and Key Access List
Hi all,
today I want to configure a dynamik acl. Following the cco doc I should configure
=========================== line vty 0 login local autocommand access-enable timeout 5 ============================= –>> this is not possible see the output below..

Rack1R3(config-line)#autocommand ? LINE Appropriate EXEC command no-suppress-linenumber Display service linenumber message
Rack1R3(config-line)#autocommand- Rack1R3(config-line)#autocommand-options ? abort-character Autocommand abort character delay Delay autocommand execution nohangup No hangup after autocommand completion
So where can I set the idle timeout ?? And also why should I configure access-group in at the ethernet interface ? I only want to restrict access on the line vty 0 4
Udo

___________________________________________________________ Telefonate ohne weitere Kosten vom PC zum PC: http://messenger.yahoo.de