.jpg "Opportunities, Appliacation, Openings"){kind=small}
.jpg "Hand Job, Blow Job, Job Search, Monster Job"){kind=small}
.jpg "pusat resume, daftar kerja, cari kerja"){kind=small}
.jpg "Project Manager, SOftware Engineer, SAP Consultant"){kind=small}
Lock and Key Access List
Hi just type the command as it is and the router will accept it will not show when you do ?.
aamir
On 8/20/06, Udo Konstantin wrote: > > Hi all, > > today I want to configure a dynamik acl. > Following the cco doc I should configure > > =========================== > line vty 0 > login local > autocommand access-enable timeout 5 > ============================= > –>> this is not possible > see the output below.. > > > > Rack1R3(config-line)#autocommand ? > LINE Appropriate EXEC command > no-suppress-linenumber Display service linenumber message > > Rack1R3(config-line)#autocommand- > Rack1R3(config-line)#autocommand-options ? > abort-character Autocommand abort character > delay Delay autocommand execution > nohangup No hangup after autocommand completion > > > So where can I set the idle timeout ?? > And also why should I configure access-group in at the ethernet > interface ? > I only want to restrict access on the line vty 0 4 > > Udo > > > > > ___________________________________________________________ > Telefonate ohne weitere Kosten vom PC zum PC: http://messenger.yahoo.de > > _______________________________________________________________________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html
