Go CCIE Go!! - A Cisco Certified Internetwork Expert

According to http://www.cisco.com/en/US/tech/tk827/tk369/technologies_tech_note09186a008040a17c.shtml -> “The tunnel keepalive mechanism functions even if the far tunnel endpoint does not support keepalives.” that is not correct.
David Prall wrote: > Yes, must be configured on both ends. The tunnel keepalive command requires > timers. > > David > > — > http://dcp.dcptech.com > > > >> —–Original Message—– >> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On >> Behalf Of ccie >> Sent: Thursday, September 18, 2008 3:11 PM >> To: ccielab@groupstudy.com >> Subject: keep alive on the tunnel interface >> >> Hi expert, >> >> If I have tunneling interface between two routers, does the >> keep alive on >> this interface send a periodic keep alive from the tunnel >> source to the >> tunnel destination. E.g. does the up of the tunnel interface >> mean that there >> is a reach ability between the tunnel source and the tunnel >> destination. >> >> Regards, >> >> Amin >> >> >> Blogs and organic groups at http://www.ccie.net >> >> ______________________________________________________________ >> _________ >> Subscription information may be found at: >> http://www.groupstudy.com/list/CCIELab.html >> > > > Blogs and organic groups at http://www.ccie.net > > _______________________________________________________________________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net