Go CCIE Go!! - A Cisco Certified Internetwork Expert

Hi friends,
I4m implementing HSRP solution between Cisco 3845 and Cisco 3745. Both routers are connected to Catalyst 6500 on differents boards. I have differents groups on active-router ( One per Vlan), and differents groups on standby router too, but I want to monitor all interfaces on router with HSRP, otherwhise, If one interface of HSRP group goes down, I want that backup router starts active.
Do you know if I can apply this config and will work fine??
interface GigabitEthernet0/0
ip address 10.133.1.2 255.255.0.0
duplex auto
speed auto
media-type rj45
standby 4 ip 10.133.1.1
standby 4 priority 105
standby 4 preempt
standby 4 track giga0/1
standby 4 track vlan12
standby 4 track vlan14

interface GigabitEthernet0/1
ip address 192.168.1.5 255.255.255.0
duplex auto
speed auto
media-type rj45
standby 7 ip 192.168.1.4
standby 7 priority 105
standby 7 preempt
standby 7 track giga0/0
standby 7 track vlan12
standby 7 track vlan14

interface Vlan12
ip address 10.100.42.5 255.255.255.248
standby 15 ip 10.100.42.1
standby 15 priority 105
standby 15 preempt
standby 15 name grupo15
standby 15 track giga0/0
standby 15 track giga0/1
standby 15 track vlan14
crypto map DELEG redundancy
!
interface Vlan14
ip address 10.100.56.5 255.255.255.248
standby 16 ip 10.100.56.1
standby 16 priority 105
standby 16 preempt
standby 16 name grupo16
standby 16 track giga0/0
standby 16 track giga0/1
standby 16 track vlan12
crypto map DELEG-3 redundancy grupo16
These commands are identical on backup router.
Thanks a lot.