Go CCIE Go!! - A Cisco Certified Internetwork Expert

Hi Rahul,
You do not need to track frame interface on R2!
However, you wont be able to use the main interface as the tracking object, because the main interface does not go down when the PVC is down. You will have to ether use subinterface (preferably point-to-point), or you need to set up IP SLA between R1 & R3 and track that IP SLA.
Regards,
Huan
—–Original Message—– From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of 2008ccie@live.com Sent: Friday, 4 July 2008 7:17 AM To: ccielab@groupstudy.com Subject: HSRP
Hi experts Would you please someone guide me? I have a HSRP configuration between two routers . The Hub (R3) router behind R1 and R2
The question is Configure HSRP between R1 and R2. use 1.1.100.1 as the gateway IP address. R1 Router is the primary router and R2 is the secondary router. R2 should become the primary router if R1 loses its connection to R3 frame-relay interface
On R1 interface fa0/1 standby 1 ip 1.1.100.1 standby 1 priority 110 standby 1 preempt standby 1 track serial0/0 20
On R2 interface fa0/0 standby 1 ip 1.1.1100.1 standby 1 priority 100 standby 1 preempt
is it correct? or may i need to configure “standby 1 track serial0/0 20″ in R2. If yes means, what is the use of this command in R2 “standby 1 track serial0/0 20″? Can anyone guide me?
Regards Rahul