.jpg "Opportunities, Appliacation, Openings"){kind=small}
.jpg "Hand Job, Blow Job, Job Search, Monster Job"){kind=small}
.jpg "pusat resume, daftar kerja, cari kerja"){kind=small}
.jpg "Project Manager, SOftware Engineer, SAP Consultant"){kind=small}
Etherchannel…
Dear Master,
If I was a question like this “User in vlan xx has been complaining about slow response, after further investigation, NOC has discovered that trunk between SW1 and SW2 has been overloaded, Configure SW1 and SW2 to have a link of 300Mbit/s and use that link efficiently and make sure fault tolerance ”
Vlanxx —–SW1(3560)=======SW2(3560)
Does it mean etherchannel with load balance?
SW1 Port-channel load-balance src-mac or Port-channel load-balance src-ip
SW2 port-channell load-balance dst-mac or dst-ip
Hmm..btw, Is there any fault tolerance in etherchannel. Just like in tunnel , there is “tunnel checksum” ==>to check/verify the packet in the tunnel
Thanks,
Yhs
