Go CCIE Go!! - A Cisco Certified Internetwork Expert

Thank goodness. I battled with this same problem for two nights.I thought i was Jinxed.

steveaggie@gmail.com wrote: Are you using dynamips? This happened to me when my CPU was over-utilized. Make sure your idlepc value is right.
—–Original Message—– From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of cisco-addicted Sent: Sunday, March 16, 2008 7:43 PM To: ‘Cisco certification’ Subject: EIGRP adjacency Flapping
Dears,
I configured a partial frame relay between three routers (R1, R2 & R3) with R2 as a HUB and R1 & R3 the spokes.

The L2 configuration for mapping the DLCI is working fine and I can ping all the interfaces with broadcast keywork added in the mapping statement.

The problem is we I configured the EIGRP AS 100 between them the adjacency come up, but I always got the following error in R3 ( the spoke) mentioning that the other Spoke’s IP address is not down.!!!!!

May someone explain what is the reason for this flapping???

Rack1R3(config-router)#
*May 9 05:25:03.785: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 100: Neighbor 183.1.123.1 (Serial1/0) is down: retry limit exceeded
Rack1R3(config-router)#
*May 9 05:25:49.965: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 100: Neighbor 183.1.123.1 (Serial1/0) is up: new adjacency
Rack1R3(config-router)#
Rack1R3#
*May 9 05:26:01.445: %SYS-5-CONFIG_I: Configured from console by console
Rack1R3#
*May 9 05:28:54.477: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 100: Neighbor 183.1.123.1 (Serial1/0) is down: retry limit exceeded
Rack1R3#
*May 9 05:29:20.069: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 100: Neighbor 183.1.123.1 (Serial1/0) is up: new adjacency
Rack1R3#

Thanks in advance gang.

Moe