Go CCIE Go!! - A Cisco Certified Internetwork Expert

What’s the codec settings on the dial peer on the cme router? The default dial peer?
Joe 800-lb gorilla, #19366

—–Original Message—– From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Godswill Oletu Sent: Wednesday, December 26, 2007 8:40 PM To: Mark Snow Cc: Cisco certification Subject: Re: CME Phone Calling CallManager DN with Partition?
Hi Mark,
It is not work out; I applied the CSS to the H323 gateway, also to the device and also to the DN.
The CallManager DN & the route pattern have the same partition. I also reset
the gateway after, but no luck.
Godswill Oletu CCIE #16464 (R&S)
—– Original Message —– From: “Mark Snow” To: “Godswill Oletu” Cc: “Cisco certification” Sent: Wednesday, December 26, 2007 8:04 PM Subject: Re: CME Phone Calling CallManager DN with Partition?
> On your H323 GW page you need to change the Calling Search Space for > inbound calls to something that contains the Partition of 6xxx. > > Change that and report back. > > Mark Snow > Sr Technical Instructor > IPexpert, Inc. > > Sent from my iPhone > > On Dec 26, 2007, at 5:49 PM, Godswill Oletu wrote: > >> I have been battling with this for sometime now. >> >> My CME gateway is registed with the CallManager via H323, the dial >> pattern on the CallManager pointing to the CME gateway is using a route >> list, then a route group that contain the CME gateway. >> >> I have a CallManager DN of e.g. 6001, in a partition call 6xxx; the dial
>> pattern pointing to the the CME gateway also have the partition of 6xxx. >> >> Results: >> With the partition in DN 6001; Ph 6001 can call CME phone, but CME phone
>> cannot call callmanager ph 6001. >> >> Without partition in DN 6001; everything works fine. >> >> are mine missing anything here? >> >> Godswill Oletu >> CCIE #16464 (R&S) >> >> _______________________________________________________________________ > > >> Subscription information may be found at: >> http://www.groupstudy.com/list/CCIELab.html