Go CCIE Go!! - A Cisco Certified Internetwork Expert

Hi Folks ; I know this has been for discussion recently ..but im not able to reach the solution from the archive ..so here we go ——–R2 ——-| R1——| R4 ———–R3——| R1,R2,R3 are on same AS 10 , R4 on AS 20 R4 advertises the lo1 netw (10.1.1.1/24) to both R2 and R3 via ebgp R2 and R3 send the network to R1 via ibgp what i want to achieve is that R1 load balance the traffic to R4 across both R2 and R3 I can see the network 10.1.1.1 on the bgp table twice , however on the routing table is shows only from R2 . I am using maximum paths 2 on R1 , but i do not have maximum-paths ibgp at all under the bgp process (version 12.2(27)) any ideas ?
——————————— How low will we go? Check out Yahoo! Messengers low PC-to-Phone call rates.