.jpg "Opportunities, Appliacation, Openings"){kind=small}
.jpg "Hand Job, Blow Job, Job Search, Monster Job"){kind=small}
.jpg "Project Manager, SOftware Engineer, SAP Consultant"){kind=small}
Basic privilege issue
Hi Farrukh,
Great technote!
If I understand it correctly, a user can’t see in the output of “sh run” what he can’t configure at his privilege level or below.
In other words, for my case I need at least the command “privilege exec level 7 configure terminal” (plus a host of other privilege commands) in order to allow him to see the selected commands. This at the same time allows him to configure those commands.
In summary, my requirement of allowing a user to view the complete “sh run” but not permitting him to configure anything cannot be achieved.
Please advise.
Thank you.
BR, Emil
On 1/5/08, Farrukh Haroon wrote: > > Hello Emil > > Have a look at this: > > > http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a00800949d5.shtml > > Regards > > Farrukh > > > On Jan 4, 2008 6:43 PM, YourPal wrote: > > > Hi Group, > > > > I have a basic problem but can’t seem to figure out why. Hope someone > > can explain it to me. Router config as follows: > > ! > > username test privilege 7 password 0 test > > ! > > privilege exec level 7 show running-config > > ! > > line vty 0 4 > > login local > > ! > > > > When user “test” telnets in and issues the command “sh run”, he sees a > > blank > > config. Why is it so? I’d like him to be able to view the config. > > > > > > Thank you. > > > > BR, > > Emil > > > > _______________________________________________________________________ > > Subscription information may be found at: > > http://www.groupstudy.com/list/CCIELab.html
