Go CCIE Go!! - A Cisco Certified Internetwork Expert

Anyone could help us on that ?
———- Forwarded message ———- From: Daniel Valle Date: Sat, Mar 29, 2008 at 5:51 PM Subject: Re: Apply MQC in switchport To: ccielab@groupstudy.com
GS, I think this config work for one match. But if we want to make two or more different matches for two or more different ports, than I don’t know how can that occur
let’s say, set DSCP CS3 for f0/13, CS4 for F0/14 and CS5 for f0/15…. All of them in vlan , let’s say 13. how can we do that ? if it is another vlan passing over the trunk… 14 for example… those matches can’t occur. what configu would solve that ? I Saw the seminar in IE site but it didn’t help me on that… I mean.. It was easy to undersand the VLAN-based traffic… but it is one single marking for all vlan ..
I’d appreciate your comments here!
Thanks,
Daniel.
On Sat, Mar 29, 2008 at 5:12 AM, wrote:
> Yes, “class any” could be any class you decide, it could be class-default > as well > > Noor > > —–Original Message—– > From: Mike M [mailto:mike_malan@yahoo.co.uk] > Sent: vrijdag 28 maart 2008 22:29 > To: Yousuf, Noor S SITI-ITIBTAE; mpurple7@yahoo.com; > gabriel.nunes@gmail.com > Cc: ccielab@groupstudy.com > Subject: RE: Apply MQC in switchport > > > Hi, all > > I understand the below config but initially was stuck > with “class any” statement in the policy-map config. > > policy-map prec > > class any > > set ip prec 5 > > service-policy interface > > I figured “class any” can be “class class-default”, as > there is no class-map called “class-map any”. > > Is this the only class-map for “class any”?? > > regards > Mike > > — Noor.Yousuf@shell.com wrote: > > > Try this, > > > > int g1/0/24 > > mls qos vlan-based > > > > class-map interface > > match input-interface g1/0/24 > > > > policy-map interface > > class interface > > > > policy-map prec > > class any > > set ip prec 5 > > service-policy interface > > > > int vlan 50 > > no ip address > > service-policy input prec > > > > Thanks, > > > > > > —–Original Message—– > > From: nobody@groupstudy.com > > [mailto:nobody@groupstudy.com]On Behalf Of > > Moses Polalysa > > Sent: woensdag 26 maart 2008 14:44 > > To: Gabriel Nunes > > Cc: ccielab@groupstudy.com > > Subject: Re: Apply MQC in switchport > > > > > > Hi, > > > > Thanks for the reply. I have tried again but it also > > not working. > > > > SW1(config-if)#exit > > SW1(config)#int vlan 10 > > SW1(config-if)#service-policy output VLAN > > Match input interface is not supported for this > > interface > > SW1(config-if)# > > > > Basically, I want to mark traffic from, let’s say, > > VLAN 50 in Gi1/0/24 with ip precedence 5. > > > > Regards, > > > > Moses > > > > > > > > —– Original Message —- > > From: Gabriel Nunes > > To: Moses Polalysa > > Cc: ccielab@groupstudy.com > > Sent: Wednesday, March 26, 2008 8:36:29 PM > > Subject: Re: Apply MQC in switchport > > > > the vlan-based command should be applied on layer 2 > > interface and service-policy on SVI interface > > > > On Wed, Mar 26, 2008 at 10:26 AM, Moses Polalysa > > wrote: > > Hi, > > > > Thanks for your reply. I have tried but still not > > work out. > > > > SW1(config-if)#mls qos vlan-based > > SW1(config-if)#service-policy out VLAN_A > > Match input interface is not supported for this > > interface > > > > SW1(config-if)# > > > > Regards, > > Moses > > > > > > > > > > —– Original Message —- > > From: Gabriel Nunes > > To: Sadiq Yakasai > > Cc: Moses Polalysa ; > > ccielab@groupstudy.com > > Sent: Wednesday, March 26, 2008 7:33:28 PM > > Subject: Re: Apply MQC in switchport > > > > I think you must configure “mls qos vlan-based” on > > switchport interface and so configure the > > service-policy on SVI interface. > > > > Gabriel > > > > > > On Wed, Mar 26, 2008 at 7:50 AM, Sadiq Yakasai > > wrote: > > Hi Moses, > > > > Not all platforms support marking traffic in all > > directions actually. > > And my guess is you are experiencing this behaviour > > on the 3560. > > > > Try going through the documentation and seeing if > > egress marking is > > supported on the 3560. Else, you could change your > > concept and mark on > > the ingress anyway. > > > > HTH > > > > Sadiq > > > > > > > _______________________________________________________________________ > > Subscription information may be found at: > > http://www.groupstudy.com/list/CCIELab.html > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > ____________________________________________________________________________________ > > Be a better friend, newshound, and > > know-it-all with Yahoo! Mobile. Try it now. > > > http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ > > > > > > > > > _______________________________________________________________________ > > Subscription information may be found at: > > http://www.groupstudy.com/list/CCIELab.html > > > > > > > > > > > > > > > > > > > > > > > > > > ____________________________________________________________________________________ > > Be a better friend, newshound, and > > know-it-all with Yahoo! Mobile. Try it now. > > > http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ > > > > > _______________________________________________________________________ > > Subscription information may be found at: > > http://www.groupstudy.com/list/CCIELab.html > > > > > _______________________________________________________________________ > > Subscription information may be found at: > > http://www.groupstudy.com/list/CCIELab.html > > > > > > __________________________________________________________ > Sent from Yahoo! Mail. > A Smarter Inbox http://uk.docs.yahoo.com/nowyoucan.html > > _______________________________________________________________________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html