Go CCIE Go!! - A Cisco Certified Internetwork Expert

Hi Eldho,
Well, this certainly sounds a little odd, my comments are inline
Carlos Campos
—–Original Message—– From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of ELDHO PAUL Sent: Wednesday, June 07, 2006 2:01 PM To: ccielab@groupstudy.com Subject: Advanced Frame-Relay Features
Hi,
While doing a CCIE scinario on frame-relay configuration I came across a question which says, ** *”Enable the R6-R8 frame connection to operate under the following conditions:
- Support for 128-bit MD5 authentication. //THIS WOULD ONLY BE A PROBLEM TO ME IF I HAD A MULTIPOINT FR INTERFACE AND I HAD TO DO SOME SORT OF AUTHENTICATION IN THE ROUTING PROTOCOL WITH 2 DIFFERENT SPOKES, THEREFORE I WOULD NEED TO DO SOMETHING LIKE PPPoFR, remember bgp, eigrp, rip and ospf (probably I’m missing something), do md5 authentication, and if you were to run chap, then that’s pppofr too. Right now I can’t think of any other possible scenario where the link wouldn’t support md5 if it was a point to point link.
- R6 and R8 are to poll each other every 15 seconds to ascertain the other side’s ability to transmit into the frame cloud.”* //THIS SOUNDS TO ME LIKE end-to-end keepalives
ANY OTHER COMMENTS ON THIS? HOPE THIS HELPS!
** Can anyone advice me how to do it.
Regards, Eldho.